Troubleshooting Method Of Mineral Water Filling Machine

When there is a problem with the beverage equipment of the mineral water filling machine series, how should we deal with it? When the filling volume of the mineral water filling machine is wrong: when filling large-scale products, the feed tank is not filled enough, resulting in unstable liquid level. You can increase the feed volume and re-adjust the ball valve above the filling head. , reset the filling time, prolong the filling time, and slow down the filling speed.
After adjusting the digital dial code or the unit, the time does not change. At this time, turn off the power and plug it in again. The liquid level of the mineral water filling machine is stable, and the filling volume is wrong: there are impurities blocking the filling pipe of the beverage equipment, mainly at the entrance of the trough or in the filling mouth, just check and clean it. There is a drip after closing: the mouth of the filling nozzle is damaged, and the mouth of the filling nozzle can be removed to repair the mouth. The size of the mouth cannot exceed 7.5mm. After repairing the aperture, slowly smooth the nozzle plane on the water abrasive paper. The ball valve in the filling head is damaged and needs to be replaced. After touching the filling control switch, there is no filling, and the digital indication LED of the time relay does not flash: the filling control switch of the beverage equipment is damaged or the base of the time relay is loose. Replace the filling control switch of the same type or press the base of the time relay tightly. . After touching the filling control switch, the digital LED display light of the time relay flickers, but no filling: carefully check whether there is air pressure or whether the air pressure is low, it may also be that the solenoid valve coil of the beverage equipment is damaged or the pneumatic valve core is stuck by foreign objects Hold, you can also unplug the power supply, open the board, turn the object or press the button next to the corresponding solenoid valve coil, if the valve can change direction, it means that the solenoid valve coil is damaged, if it cannot change direction, it is the valve core. If it is stuck, replace the solenoid valve coil or disassemble the valve to deal with it.