Maintenance Method Of Granule Packaging Machine

What is the maintenance method in the daily use of the granule packaging machine? The granule packaging machine is suitable for items packed in powder and granules with good fluidity. The granule packaging machine is seen in many industries, but for the granule packaging machine, maintenance and maintenance are very important in daily use. It can increase the life of the granule packaging machine, so what is the maintenance method in the daily use of the granule packaging machine?
The daily maintenance methods of the granule packaging machine are as follows:
1. Regularly check the parts, once a month, whether the bolts on the lubricating block, bearings and other moving parts are flexible and worn, and should not be used reluctantly.
2. The machine should be used in a dry and clean room, and should not be used in places where the atmosphere contains acids and other gases that are corrosive to the body.
3. After the machine is used or stopped, the rotating drum should be taken out to clean and brush the remaining powder in the bucket, and then install it properly to prepare for the next use.
4. If the machine is not used for a long time, the whole body of the machine must be wiped clean, and the smooth surface of the machine parts should be coated with anti-rust oil and covered with a cloth awning.
5. When the drum moves back and forth during work, please adjust the M10 screw on the front bearing to the proper position.
When we all maintain the granule packaging machine, we can maintain it according to the above maintenance methods. The correct way to maintain our packaging machine is what we all want.
Instructions:
1. Before starting the granule packaging machine, check whether the specifications of the installed container and bag maker meet the requirements.
2. Pull the main motor belt by hand to see if the pellet packaging machine is running flexibly. After confirming that there is no abnormality in the pellet packaging machine, it can be powered on.
3. Under the granule packaging machine, install the packaging material between the two paper stop rollers, and place it in the groove of the paper holder arm board of the granule packaging machine. Align the bag holder, then tighten the knob on the baffle, and ensure that the printed side faces forward or the composite side (ie, the polyethylene side) faces back.
4. Turn on the main power switch of the granule packaging machine, press the clutch handle to separate the metering mechanism from the main drive, turn on the start switch, and the machine runs idly.
5. If the conveyor belt rotates clockwise, it should be stopped immediately. At this time, the main motor is reversed. After the motor is reversed, the belt rotates counterclockwise.
6. Set the temperature. According to the packaging materials used, set the heat sealing temperature on the temperature controller of the electric control box.
7. Adjustment of bag length Put the packaging material into the bag maker according to relevant regulations, clamp it between two rollers, turn the roller, and pull the packaging material below the cutter. After reaching the set temperature for 2 minutes, turn on the start switch. Loosen the lock nut of the bag length adjusting screw, adjust the handle of the bag length controller, and turn it clockwise to shorten the bag length.
8. When shutting down, the heat sealer must be in the open position to prevent burning of the packaging material and prolong the service life of the heat sealer.